JBL 100 WPC Stereo Power Amplifier, Bridgeable Synthesis S300
$245.00
Out of stock
Email when stock available
JBL’s Synthesis S300 is a 100 Watt Per Channel Stereo Power Amplifier, Bridgeable to 300 Watts at 8 Ohms, Made in the USA
Features:
Rack-Mountable, Rugged Construction Discrete, Low-Distortion Circuitry Auto-Variable-Speed Forced Air Cooling Dual Gain Controls
Specifications:
Power Per Channel at 8 Ohms: 100 Watts, at 4 Ohms: 150 Watts, Bridged Mono at 8 Ohms: 300 Watts (Switchable)
Harmonic Distortion less than .1%
Bandwidth: (-3dB) 2Hz – 100kHz
Inputs: XLR Balanced
Outputs: 5-Way bindings suitable for banana plugs
Dimensions: H: 3.5″ x W: 19″ x D: 17″, Weight: 40.5 lbs.
Asking $245 for this very solid JBL Power Amplifier, made in the USA.
| Weight | 45.5 lbs |
|---|---|
| Dimensions | 7.5 × 23 × 21 in |
Related Products
NAD C 272 Stereo Power Amplifier 150 WPC, 300 Watts Bridged
Start with the number that is not on the front: 150 watts per channel into 8 ohms and 150 into 4. Most amplifiers quote a comfortable 8 ohm figure and hope you never connect anything harder; this one holds its full rating into half the impedance, from a high-current Holmgren toroidal feeding all-discrete circuitry with NAD's PowerDrive topology behind it. A BRIDGE MODE switch on the back turns it into a single mono channel of roughly 300 watts into 8 ohms, so the system can be rearranged later rather than replaced. Very Good condition.
Hafler DH-200 Power Amplifier — 100 WPC MOSFET, Made in USA
David Hafler's second act, and the amplifier that put MOSFETs into American hi-fi.
✔️ Condition: Very Good
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
Rotel RB-870 Stereo Power Amplifier – 60 WPC, Bridgeable to 120
Sixty watts a channel into 8 ohms at 0.03% distortion, a damping factor of 280, and response running out to 120kHz. A rear-panel switch bridges the two channels into a single 120-watt mono amplifier, so a second one later gives you monoblocks. The speaker terminals clamp bare wire or spades only — no bananas. Very good condition, inspected and tested.
