Retro 90’s Style 4-Way Sharp Speakers CP-BA200
$75.00
Four drivers a side: a 5.25-inch subwoofer, a 5.25-inch woofer, a 2-inch tweeter and a 0.75-inch super-tweeter, rated 100 watts RMS at 6 ohms. Thirteen inches tall, 10.3 lbs each, in squared-off 1990s Sharp styling. If the retro look does not put you off, that is a lot of driver for the money.
1 in stock
Retro 90’s Style 4-Way Sharp Speakers
If you’re ok with the retro look, and are working with a limited budget, these 4-Way speakers from Sharp are surprisingly good for the price.
Each one boasts a 5.25″ Subwoofer, a 5.25″ Woofer, a 2″ Tweeter, and .75″ Super-Tweeter.
They are rated for 100 Watts RMS at 6 Ohms impedance.
Dimensions: Width; 10-5/8″ (270 mm), Height; 13″ (330 mm), Depth; 10-3/8″ (264.6 mm), Weight: 10.3 lbs. (4.7 kg)/each
Asking just $75 for these retro-look 4-Way speakers.
| Weight | 22.6 lbs |
|---|---|
| Dimensions | 26.6 × 14.7 × 17 in |
Related Products
Mission 731 Bookshelf — Made in England, Inverted Driver Design
Two things to tell you: a ding on the top side edge of one cabinet, and third-party binding posts a previous owner fitted to one speaker. Otherwise good — and the design is the interesting part, since Mission's inverted geometry puts the tweeter below the woofer to bring the two into step at seated ear height. Made in England.
Bowers & Wilkins WM2 Outdoor Speakers, Pearl White, w/ Brackets
On an outdoor speaker the condition is the whole story — these are almost never retired for how they sound, but for sun turning a white cabinet chalky and yellow, freeze-thaw working at the seams, and grilles blooming with rust. Pearl White shows all of it more plainly than black would, and this pair grades Very Good, factory wall brackets included. B&W did not design a weatherproof box and then find a driver to fit it either: a 130 mm woven fibreglass cone crossed at 3.5 kHz to a 25 mm dome, the same material philosophy as their indoor speakers.
Castle Knight 1 Bookshelf Speakers — Real Wood Cherry, Pair
From a Yorkshire company that spent forty years being known for its cabinets above all else. The cherry veneer is deep-figured real timber, book-matched across the two cabinets so the grain mirrors when they are set up together, then sealed and waxed by hand over more than five days. Underneath is an honest two-way bass-reflex with a 130 mm woven natural-fibre bass/mid driver and five-way binding posts. Very Good condition.
Camber Laser 3 Bookshelf Speakers – Made in Ottawa, Canada
Built in Ottawa, a short drive from where they now sit. A 6.5-inch Audax mid-bass on a translucent polypropylene cone and a 1-inch dome with a centre diffusor, in light grey bezels against a dark cabinet. Two-way rear-ported, 8 ohms, 10 to 100 watts, spring clips on the back — give them room off the wall. Grilles included; very good condition.
Paradigm Monitor 3 v3 Bookshelf Speakers – 8″ Woofer, Canada
An 8-inch woofer in a cabinet small enough to sit on a stand — a 210 mm ICP cone on a die-cast chassis, with a third-generation titanium dome on the Studio-series waveguide faceplate, crossed at 2.0 kHz. Low frequency extension to 38 Hz and 91 dB room sensitivity, so 15 watts drives them and 150 is just headroom. Built in Canada, in Black Ash. Very good condition.
PSB Century 300i Bookshelf Speakers – 6.5″ Woofer, Canada
MartinLogan Motion 15 Bookshelf Speakers – Folded Motion, Boxed
The reason to want these is the tweeter — MartinLogan's Folded Motion driver is a pleated ribbon rather than a dome, so it squeezes air out from between its pleats and barely has to move. A 5.25-inch aluminium cone below it, 92 dB sensitivity, and the high-gloss black clean of the swirls these show so readily. Original boxes included.
Polk Audio RTi6 Bookshelf Speakers – Real Wood, Bi-Wireable
JBL 62T Bookshelf Speakers – Rosewood Finish, Titanium Dome
Discounted for the aftermarket screw holes a previous owner left in the back panels, and very good everywhere else — original drivers, clean rosewood finish, both tested here. A mid-1980s two-way with a pure titanium tweeter that runs out to 23 kHz, and an easy 89 dB load that a thirty-watt vintage receiver drives properly.
