Martin Logan 10″ Active Subwoofer 360 Watt Peak MLT-2 Sub
$195.00
A 10-inch high-excursion paper cone on a 120-watt RMS amplifier, 360 watts peak, rated down to 37 Hz. Variable low-pass from 50 to 200 Hz, auto power-on, left/right and LFE line inputs. Straight answer on this one: it only stays tight at low and moderate volumes, so it is not a high-volume sub. We normally list this model at $295 and have dropped it accordingly.
1 in stock
The MLT-2 Sub made by Martin Logan is a 10″ Active Subwoofer boasting 360 Watt Peak performance. It delivers impressive power and bass response in a compact (but solidly built) cabinet.
This Martin Logan features a 10″ high-excursion, paper cone, 120 Watt RMS Amplifier, Auto Power On, Variable Low Pass Filter Frequency from 50–200Hz, Left & Right/LFE RCA Line Level inputs, and rated Frequency Response down to 37 Hz.
Dimensions:16″ x 11.5″ x 15.5″ / 32.6 lbs.
Original MSRP of $995 USD as part of a compact but good quality 5.1 System.
We normally list this model for $295, but this particular subwoofer only sounds tight at low and moderate volumes, definitely not a good option for high volume listening. So we have reduced it to just $195.
| Weight | 37 lbs |
|---|---|
| Dimensions | 20 × 15.5 × 19.5 in |
Related Products
Mirage LF-150 10″ Powered Subwoofer – 600W Peak, Made in Canada
A discrete MOSFET Class A/B amplifier rated 150 watts continuous and 600 watts dynamic peak, driving a 10-inch polypropylene titanium-deposit woofer on a 1.5-inch voice coil and a 28-ounce magnet. Front-ported to 23 Hz, with level, phase and crossover on the front panel instead of the back. Made in Canada, 45 lbs; very good condition.
JVC SX-PW33 Slim Tower Subwoofer — 6.5in, 100W, High-Pass Out
A tall, narrow bass column meant to stand beside a cabinet rather than in front of it — 8.25 inches across the front and unusually deep at 17, which is the trade: the depth buys back the internal volume the narrow baffle gives away, so a 6.5 inch woofer is properly loaded in a strip of floor barely wider than a hardcover book. Driven by an integrated 100 watt amplifier, with speaker-level inputs and high-pass outputs so it works with an amplifier that has no subwoofer output at all. Good condition.
LG SH96TA-W Passive Subwoofer, Front-Firing, Front-Ported, Black
The passive subwoofer that shipped with LG's SH96TA home-theatre system — forward-firing driver and a front port, so it can back onto a wall or sit inside a cabinet without upsetting the tuning. It is a 3-ohm load and needs a receiver with a dedicated passive-subwoofer output; it should not go on ordinary speaker terminals. No power cord, no plate amp to age out. Good cosmetic condition.
Infinity Modulus MSW-II 12″ Powered Subwoofer – 600W Peak
Polk Audio PSW350 10″ Front-Firing Powered Subwoofer 260W
A 10-inch front-firing Dynamic Balance woofer on a 100-watt RMS amplifier — 260 watts dynamic — in a dual-rear-ported cabinet good for 25 to 180 Hz. Speaker-level in and out, stereo line inputs and an unfiltered LFE jack, with a variable 60 to 160 Hz low-pass and a phase switch. 37 lbs, black matte. Very good cosmetic condition.
Yamaha YST-SW105 Active Servo Subwoofer — Compact 100W
An 8-inch front-firing paper cone on Yamaha's Advanced Active Servo amplifier — 100 watts into 5 ohms, down to 30 Hz, from a cabinet small enough to tuck beside a bookshelf pair. Continuously variable high-cut from 50 to 150 Hz, a Music/Movie voicing switch, RCA and speaker-level inputs plus full-range pass-through outputs. Very good condition.
Yamaha SW-3 Active Servo Subwoofer — 10″ Woofer | Air Woofer Tec
Yamaha’s Active Servo Technology couples a negative-impedance drive amplifier to a Helmholtz resonator port — the Air Woofer opening — so the amplifier corrects the driver’s motion as it works. 100 watts into a 25 cm cone, rated down to 25 Hz, with a continuously variable 50–150 Hz high-cut at 24 dB per octave. Speaker-level and line inputs both. Very good condition.
