


Paradigm 10″ Active Subwoofer Cin 110CT Sub v3
$195.00
Out of stock
Email when stock available
Recent model Paradigm 10″ Active subwoofer in good condition.
Its built-in, advanced, high-power discrete amplifier provides high-current, low-distortion power. Advanced fiber-reinforced cone ensures clean, clear extended bass performance with tremendous output and superb control, while high-velocity low-noise ports with critically flared openings supply maximum output efficiency and minimal turbulence distortion. The Cinema 110 CT subwoofer’s high-density hardboard enclosure limits panel resonances for clean, tight bass performance.
Low Frequency Driver: 254-mm (10 in) fiber-reinforced cone, 51-mm (2 in) voice coil, oversized magnet
Built-in Amplifier rated at 150 Watt RMS / 450 Watt Peak output.
Control Facilities:
• Auto On, • Subwoofer Level, • Subwoofer Cut-Off Frequency (continuously variable 50 Hz – 200 Hz), • Subwoofer Phase Switch
Input Facilities:
• Line-level Input
Dimensions: HxWxD 16.25″ × 12″ × 15″, Weights: 37lbs
Asking $195 for this 10″ Paradigm Subwoofer in good condition.
| Weight | 44 lbs |
|---|---|
| Dimensions | 19 × 16 × 20.25 in |
Related Products
Yamaha YST-SW105 Active Servo Subwoofer — Compact 100W
An 8-inch front-firing paper cone on Yamaha's Advanced Active Servo amplifier — 100 watts into 5 ohms, down to 30 Hz, from a cabinet small enough to tuck beside a bookshelf pair. Continuously variable high-cut from 50 to 150 Hz, a Music/Movie voicing switch, RCA and speaker-level inputs plus full-range pass-through outputs. Very good condition.
Yamaha SW-3 Active Servo Subwoofer — 10″ Woofer | Air Woofer Tec
Yamaha’s Active Servo Technology couples a negative-impedance drive amplifier to a Helmholtz resonator port — the Air Woofer opening — so the amplifier corrects the driver’s motion as it works. 100 watts into a 25 cm cone, rated down to 25 Hz, with a continuously variable 50–150 Hz high-cut at 24 dB per octave. Speaker-level and line inputs both. Very good condition.
Mirage LF-150 10″ Powered Subwoofer – 600W Peak, Made in Canada
A discrete MOSFET Class A/B amplifier rated 150 watts continuous and 600 watts dynamic peak, driving a 10-inch polypropylene titanium-deposit woofer on a 1.5-inch voice coil and a 28-ounce magnet. Front-ported to 23 Hz, with level, phase and crossover on the front panel instead of the back. Made in Canada, 45 lbs; very good condition.
JVC SX-PW33 Slim Tower Subwoofer — 6.5in, 100W, High-Pass Out
A tall, narrow bass column meant to stand beside a cabinet rather than in front of it — 8.25 inches across the front and unusually deep at 17, which is the trade: the depth buys back the internal volume the narrow baffle gives away, so a 6.5 inch woofer is properly loaded in a strip of floor barely wider than a hardcover book. Driven by an integrated 100 watt amplifier, with speaker-level inputs and high-pass outputs so it works with an amplifier that has no subwoofer output at all. Good condition.
LG SH96TA-W Passive Subwoofer, Front-Firing, Front-Ported, Black
The passive subwoofer that shipped with LG's SH96TA home-theatre system — forward-firing driver and a front port, so it can back onto a wall or sit inside a cabinet without upsetting the tuning. It is a 3-ohm load and needs a receiver with a dedicated passive-subwoofer output; it should not go on ordinary speaker terminals. No power cord, no plate amp to age out. Good cosmetic condition.
Infinity Modulus MSW-II 12″ Powered Subwoofer – 600W Peak
Polk Audio PSW350 10″ Front-Firing Powered Subwoofer 260W
A 10-inch front-firing Dynamic Balance woofer on a 100-watt RMS amplifier — 260 watts dynamic — in a dual-rear-ported cabinet good for 25 to 180 Hz. Speaker-level in and out, stereo line inputs and an unfiltered LFE jack, with a variable 60 to 160 Hz low-pass and a phase switch. 37 lbs, black matte. Very good cosmetic condition.








