Yamaha Natural Sound 50 WPC Stereo Receiver w/ Phono R-5
$195.00
Out of stock
Email when stock available
Yamaha Natural Sound 50 WPC Stereo Receiver with Phono, Made in Japan.
Very nice vintage Yamaha, boasting rotary Bass, Treble, Balance, and Loudness Controls, Servo Lock Tuning System with 10-Step Signal Quality Meter, 3 Pairs of RCA analog inputs including dedicated Phono stage, support for one or two pairs of speakers.
Specifications:
Tuning range: FM, AM
Power output: 50 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.015%
Damping factor: 50
Input sensitivity: 2.5mV (MM), 150mV (line)
Signal to noise ratio: 88dB (MM), 103dB (line)
Channel separation: 55dB (MM), 52dB (line)
Output: 150mV (line)
Speaker load impedance: 6Ω (minimum)
Dimensions: 435 x 126 x 289mm, Weight: 5.6kg
Includes soft copy of manual in PDF.
Asking $195 for this great sounding vintage, made in Japan Yamaha Stereo receiver, tested thoroughly and working perfectly.
| Weight | 14.35 lbs |
|---|---|
| Dimensions | 21.13 × 8.96 × 15.38 in |
Related Products
Pioneer SX-50 Silver Face Receiver – 50 WPC, Pre-Outs, 1983
Fifty watts a channel into 8 ohms at 0.007% distortion, and — unusually for a receiver this size — pre-out and main-in jacks on the back, so it can feed a subwoofer, take an equalizer in the loop, or hand off to a larger power amp. Introduced in 1983 with switchable CD and TV audio inputs, presets held by three AA cells, and the silver face of the decade that was ending. Graded Very Good.
Kenwood KR-A4070 Stereo Receiver – 60WPC, Phono, Original Remote
Sixty watts a channel into 8 ohms across the full band at 0.01% distortion, with an MM phono input at 2.5mV, a tape monitor loop, and separate bass, treble and balance. The original Kenwood remote is here, which is uncommon on a receiver of this age. Level 1 serviced; cosmetically graded Good, with honest wear for its years.
Sherwood S-7250 CP Stereo Receiver – 20WPC, Phono, Wood Cabinet
Twenty watts a channel into 8 ohms across the full 20 Hz to 20 kHz band, an MM phono input at 80 dB signal-to-noise, and a tape monitor loop. Sherwood built these in small runs in Chicago and sold them through the same shops that carried Marantz and McIntosh. Still in its original wood cabinet. Level 1 serviced here; condition Very Good.
Luxman R-117 Flagship Stereo Receiver — 160 WPC, MM & MC Phono
Aurex (Toshiba) SA-5000 Stereo Receiver — 50 WPC, Made in Japan
Technics SA-600 AM/FM Stereo Receiver 70 WPC — Japan
Sherwood S-8250 CP AM/FM Stereo Receiver 25 WPC
Twenty-five watts a channel into 8 ohms from Sherwood's Certified Performance series — the range where Sherwood printed the measured figures for the individual unit rather than for the model. MM phono, noise filter, mute/mono, loudness and A/B speakers, behind a brushed aluminium face with walnut-grain side panels. Level 2 serviced here: bias and DC offset set, every control deoxidised.
JVC JR-S201 Receiver – 35 WPC, Japan, SEA EQ, Excellent
Thirty-five watts a channel at 0.01% distortion with a damping factor of 70 — numbers most larger receivers of 1978 could not reach. A five-band S.E.A. graphic equalizer sits on the front panel at 40, 250, 1k, 5k and 15kHz, alongside MM phono, two tape loops and push-button speaker terminals. Made in Japan, arrived professionally serviced; cosmetically graded Excellent.
