


NAD 55 WPC Integrated Amplifier w/ MM/MC Phono 3155
$445.00
Out of stock
Email when stock available
Audiophile quality Stereo Receiver from NAD, boasting plenty of power (55 ultra-conservative NAD Watts per channel), and switchable MM/MC Phono input.
From NAD: “NAD leads the audio industry in producing amplifiers with high-headroom circuitry and high-current output stages, precisely the qualities needed for musically accurate reproduction of today’s wide-range analogue and digital recordings. The 3155 integrated amplifier is the finest in a long tradition of highly praised NAD amplifiers, with increased power, improved reliability, and numerous refinements in sound quality. The 3155 is two products in one. As a preamplifier it matches most separate audiophile preamps in sonic performance and surpasses them in operating flexibility. As a high-current high-headroom power amplifier it drives even “difficult” loudspeakers to surprisingly high volume levels with clean, solid, full-bodied musical sound that remains refreshingly free from distortion even in transient peaks. NAD 3155 offers another traditional NAD virtue: an impressive ratio of performance to price.”
Features: Pre Out / Main In Speakers: A, B, A+B, Off 2~16 Ohms Phono MM/MC, Tuner, CD/Aux, Tape1/Aux2, Tape2/Aux3 Phono: 100-300 pF switch Loudness Bass EQ Infrasonic filter Stereo/Mono Multi-position Rec/Playback selection Soft clipping On/Off -20dB switch Fuse, relay and circuit DC protection
Made in Japan, 1987 55 WPC RMS at 8 Ohm Dynamic power: 102 Watts/ch at 8 Ohm Bridged mono: 125 Watts at 8 ohm, 250 W/ch peak power Label: 340 VA THD: 0.04% at full power THD: 0.01% at 1 Watt output (normal listening level) Damping factor: 50
Dimensions: 42 x 10.8 x 38 cm, Weight: 8.4 KG, 18.5 lbs
Asking just $445 for this freshly serviced, great sounding NAD Stereo power-house with switchable MM/MC Phono input.
| Weight | 21 lbs |
|---|---|
| Dimensions | 19 × 20.5 × 8 in |
Related Products
Technics SU-V76 New Class A Integrated Amp 100 WPC — Japan
A 1987 New Class A integrated: pure Class A at low levels, sliding to Class A/B when the music asks for it, 100 watts a channel into 8 ohms at 0.05% distortion. It draws about 30 watts at idle, which is how you know the Class A bias is real rather than a label. MM phono and A/B speaker switching. Level 1 serviced; good cosmetic condition.
Monster Technics SU-G90 130 WPC Integrated Amp – Made in Japan
130 watts a channel into 8 ohms with both channels driven at 0.05% distortion, six analog inputs and an MM phono stage. This 1991 design also carries a Dolby Pro Logic decoder with its own 15-watt rear amplifier section, so it can run a compact surround setup on its own. Made in Japan; good cosmetic condition.
Sansui A-900P 70 WPC Integrated Amplifier – Made in Japan
Seventy watts a channel into 8 ohms at 0.05% distortion, from a DC servo output stage, with frequency response running from 5 Hz to 60 kHz. Moving-magnet phono at 2.5mV, line inputs for tuner, CD and aux, and a tape monitor loop for an outboard EQ. Built in Japan between 1985 and 1986. Condition very good; inspected and tested.
LXI AM4002 Integrated Amplifier 80 WPC (est), Dual Phono
Sold through Sears in the late seventies and heavier than that suggests — 22.9 lb, a 450 VA power rating, and metal knobs on everything. Two separate phono inputs, tape monitor and dubbing, subsonic and high filters, A/B speakers, and a front-panel mic mixing input. No factory manual survives, so the 80 WPC is our own conservative estimate. Level 1 serviced here; good cosmetic condition.







