Integrated amplifiers from Marantz, Luxman, Technics, Arcam, Sony and more. Every piece is bench-tested, serviced as required and covered by our Bumper-to-Bumper Warranty. Pick up free in Kanata by appointment, or have it shipped across Canada and internationally.

Showing 1–12 of 41 resultsSorted by price: high to low

Show sidebar
Show 9 12 18 24

17 in stock · 24 sold

Filter & sort
to
Clear all
Marantz Model 1200 integrated amplifier front panel in brushed silver, with slider bass and treble controls, rotary knobs and a centre tape monitor switch
Marantz Model 1200 seen from the front left, showing the silver faceplate, black perforated cover and the finned heat sinks along its side
Compare

Marantz 1200 Vintage Integrated Amplifier – 100 WPC, Made in USA

, ,
$1,895.00

Marantz's flagship integrated of the early seventies, built in Sun Valley, California, through our Level 2 service and playing as it should.

✔️ Very Good condition — faceplate and knobs present well, light marks of age; offered in the stock black metal case
✔️ Through our Level 2 service — a substantial round of component replacement on the bench, then bias and offset set and the amp run in
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping

Add to wishlist
Marantz Model 1070 straight on: brushed silver faceplate with selector and volume knobs, slider tone and balance controls, mic and phones jacks
Marantz Model 1070 straight on: brushed silver faceplate with selector and volume knobs, slider tone and balance controls, mic and phones jacks
Compare

Marantz 1070 Vintage Integrated Amplifier – 35 WPC, Serviced

, ,
$995.00

A slim mid-seventies Marantz integrated amplifier, through our Level 1 service, in very good condition, with a phono stage, a three-band tone section and a microphone input on the front panel.

✔️ Very good condition — free of significant marks
✔️ Through our Level 1 service on our own bench
✔️ MM phono stage, three-band tone sliders and a front-panel mic input
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping

Add to wishlist
YBA YA201 integrated amplifier, 100 WPC: front view of the minimalist black fascia
YBA YA201 integrated amplifier: rear panel with RCA inputs, speaker binding posts and power inlet
Compare

YBA YA201 Integrated Amplifier – 100 WPC, French Design

, ,
$895.00

A YBA YA201 two-channel integrated amplifier from YBA's Design Series, tested and fully functional.

✔️ 100 watts per channel into 8 ohms
✔️ Six line-level inputs (no phono stage)
✔️ Oversized linear power supply and YBA's Triple Push output stage
✔️ Tested and fully functional
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping

Add to wishlist
Denon PMA-600NE integrated amplifier — front panel with volume control and input selector
Denon PMA-600NE — rear panel with speaker terminals, phono ground and digital inputs, power cord alongside
Compare

Denon PMA-600NE Integrated Amplifier – 45 WPC, Phono, Bluetooth

, ,
$495.00

A current model, not a discontinued one — Denon still builds the PMA-600NE, so parts, service and support are all still in production behind it. Forty-five watts a channel with an MM phono stage, a 192 kHz/24-bit DAC, Bluetooth and tone controls. Excellent condition, with the original remote.

Add to wishlist
Blaupunkt Micronic A-60 micro integrated amplifier, silver faceplate with LED power meters, bass, treble, balance and volume knobs
Blaupunkt Micronic T-60 AM/FM tuner and preamplifier, silver faceplate with dial, LED signal meter and source buttons
Compare

Blaupunkt Micronic A-60 + T-60 Micro System – 20 WPC, Bundle

, , ,
$445.00

The complete Blaupunkt Micronic 60 system from 1981, the A-60 amplifier and the matching T-60 AM/FM tuner and preamplifier, together for less than buying them separately.

✔️ Tested on our bench, both units
✔️ Both very good
✔️ Radio, phono, tape and a 20-watt amplifier in a stack 25 cm wide
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping

Add to wishlist
Braun Atelier A1 integrated amplifier, front panel with its row of source and tone controls and the A1 badge at the right.
Braun Atelier A1 at an angle, showing the 70 mm chassis and the vented top cover.
Compare

Braun Atelier A1 Vintage Integrated Amp – 55 WPC, Pre-Out, Japan

, ,
$445.00

The component that makes the rest of an Atelier system work, and the one people hunting these usually look for first. 55 watts per channel into 8 ohms and 80 into 4, with a preamplifier section that separates from the power stage — engineering that is not an afterthought to the industrial design. 445 mm wide and 70 mm tall, the exact footprint of the T1 tuner and C1 deck, so the stack reads as one machined object. Made in Japan for Braun. Good condition.

Add to wishlist
Sony TA-1630 integrated amplifier: front panel with volume and function controls
Sony TA-1630: angled view showing the walnut-finish side panels
Compare

Sony TA-1630 Vintage Integrated Amplifier – 22 WPC, Serviced

, ,
$445.00

A vintage Sony TA-1630 integrated stereo amplifier with its original walnut-finish side panels, Level One serviced and thoroughly tested.

✔️ 22 watts per channel into 8 ohms
✔️ Phono (MM), tuner, aux and tape inputs, with A/B speaker switching
✔️ Original walnut-finish side panels and a brushed silver face
✔️ Level One service and thorough testing
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping

Add to wishlist
Akai AM-U41 integrated amplifier front panel in silver, viewed from above
Akai AM-U41 integrated amplifier at a three-quarter angle showing the brushed faceplate
Compare

Akai AM-U41 Vintage Integrated Amplifier – 55 WPC, MM/MC Phono

, ,
$395.00

Fifty-five watts a channel into 8 ohms at 0.007% distortion, from a dual supply with separate bridge rectifiers and filter capacitors for each channel. True moving coil phono at 0.25mV sits alongside the 2.5mV moving magnet input, and there is a midrange control at ±6dB — rare on a consumer amplifier. Built in Japan, 1982 to 1983. Level 1 serviced here; condition very good.

Add to wishlist
LXI AM4002 integrated amplifier front panel in black with volume control and source buttons
LXI AM4002 integrated amplifier angled, showing the chassis depth
Compare

LXI AM4002 Vintage Integrated Amp – 80 WPC (est.), Dual Phono

, ,
$345.00

Sold through Sears in the late seventies and heavier than that suggests — 22.9 lb, a 450 VA power rating, and metal knobs on everything. Two separate phono inputs, tape monitor and dubbing, subsonic and high filters, A/B speakers, and a front-panel mic mixing input. No factory manual survives, so the 80 WPC is our own conservative estimate. Level 1 serviced here; good cosmetic condition.

Add to wishlist
Technics SU-G90 Integrated Amplifier – 130 WPC, Made in Japan
Compare

Technics SU-G90 Integrated Amplifier – 130 WPC, Made in Japan

, ,
$345.00

130 watts a channel into 8 ohms with both channels driven at 0.05% distortion, six analog inputs, an MM phono stage, and a separable pre-out/main-in loop for an active crossover or external amp. This 1991 design also carries a Dolby Pro Logic decoder with its own 15-watt rear amplifier section, so it can run a compact surround setup on its own. Made in Japan; good cosmetic condition.

Add to wishlist
harman/kardon PM640 Vxi integrated amplifier, black brushed faceplate with power and headphone controls, tone knobs and a large volume dial
harman/kardon PM640 Vxi turned to the right, showing the vented top cover and the full width of the black front panel
Compare

Harman Kardon PM640VXi Vintage Integrated Amp – 45 WPC, Japan

, ,
$295.00

A 45-watt amplifier built by a company that spent the 1980s arguing the watts were the wrong thing to look at.

✔️ Condition: Very Good
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping

Add to wishlist
Luxman LV-90 integrated amplifier — black faceplate with input selector and large volume control
Luxman LV-90 rear panel — RCA inputs, speaker terminals and the mains lead
Compare

Luxman LV-90 Vintage Integrated Amplifier – 35 WPC, Phono, Japan

, ,
$295.00

Lux Corporation's compact integrated, built in Tokyo in 1986–87: 35 watts a channel at 0.008% distortion, a real phono stage, and a volume control calibrated in decibels of attenuation rather than arbitrary numbers. CD Straight bypasses the tone circuitry when you want the short path.

Add to wishlist

Questions about Integrated Amplifiers

Is used gear from Radique tested?
Yes. Every piece is bench-tested before it is listed and serviced as required. Anything we service gets a second bench test by a different tech, and anything we ship is tested once more before it is packed.
What warranty comes with it?
Our 90-day Bumper-to-Bumper Warranty: if it fails in normal use, we repair or replace it at our expense and give you a fresh 90 days. On eligible items over $500 you can add an Extended Warranty of 1, 2 or 3 years.
Can I trade it in later?
Yes. Through our Perpetual Trade-Back Program you can trade it back any time for store credit toward other used or vintage gear: 100% of what you paid in the first 30 days, and never less than 50%.
Do you ship, and can I pick up?
Pickup in Kanata (Ottawa) is free, by appointment. To have it shipped, add it to your cart and enter your city and postal code on the cart page to see live carrier rates. We ship across Canada and internationally.