Kenwood 100 WPC Stereo Receiver w/ Phono & Sub AR-404
$195.00
100 watts a channel into 8 ohms, with an MM phono stage at 2.5 mV and a subwoofer pre-out — an unusual pairing on a receiver at this money. Four pairs of line inputs besides phono, two pairs of outputs, and A/B or A+B speaker switching. 8 kg. A PDF copy of the manual comes with it.
1 in stock
Kenwood 100 WPC Stereo Receiver with Phono & Subwoofer Pre-out
Very nice feature combination paired with great power and good fidelity for an attractive price.
Includes 4 pairs of analog inputs, plus Phono, in addition to two pairs of analog outputs. Supports dual pairs of stereo speakers: A/B, A+B
Power output: 100 watts per channel into 8Ω (stereo)
Frequency response: 40Hz to 20kHz
Total harmonic distortion: 0.5%
Input sensitivity: 2.5mV (MM), 200mV (line)
Signal to noise ratio: 75dB (MM), 92dB (line)
Output: 200mV (line), 2V (Pre out)
Dimensions: 440 x 144 x 389mm, Weight: 8kg
If you’re looking for a budget stereo receiver with good power, phono and sub pre-out, it’s hard to go wrong with this Kenwood.
Includes soft copy of manual in PDF. Asking just $195 for this well equipped Kenwood stereo receiver.
| Weight | 19.64 lbs |
|---|---|
| Dimensions | 21.32 × 9.67 × 19.31 in |
Related Products
Sherwood S-7250 CP Stereo Receiver – 20WPC, Phono, Wood Cabinet
Twenty watts a channel into 8 ohms across the full 20 Hz to 20 kHz band, an MM phono input at 80 dB signal-to-noise, and a tape monitor loop. Sherwood built these in small runs in Chicago and sold them through the same shops that carried Marantz and McIntosh. Still in its original wood cabinet. Level 1 serviced here; condition Very Good.
Luxman R-117 Flagship Stereo Receiver — 160 WPC, MM & MC Phono
Aurex (Toshiba) SA-5000 Stereo Receiver — 50 WPC, Made in Japan
Technics SA-600 AM/FM Stereo Receiver 70 WPC — Japan
Sherwood S-8250 CP AM/FM Stereo Receiver 25 WPC
Twenty-five watts a channel into 8 ohms from Sherwood's Certified Performance series — the range where Sherwood printed the measured figures for the individual unit rather than for the model. MM phono, noise filter, mute/mono, loudness and A/B speakers, behind a brushed aluminium face with walnut-grain side panels. Level 2 serviced here: bias and DC offset set, every control deoxidised.
JVC JR-S201 Receiver – 35 WPC, Japan, SEA EQ, Excellent
Thirty-five watts a channel at 0.01% distortion with a damping factor of 70 — numbers most larger receivers of 1978 could not reach. A five-band S.E.A. graphic equalizer sits on the front panel at 40, 250, 1k, 5k and 15kHz, alongside MM phono, two tape loops and push-button speaker terminals. Made in Japan, arrived professionally serviced; cosmetically graded Excellent.
Pioneer SX-50 Silver Face Receiver – 50 WPC, Pre-Outs, 1983
Fifty watts a channel into 8 ohms at 0.007% distortion, and — unusually for a receiver this size — pre-out and main-in jacks on the back, so it can feed a subwoofer, take an equalizer in the loop, or hand off to a larger power amp. Introduced in 1983 with switchable CD and TV audio inputs, presets held by three AA cells, and the silver face of the decade that was ending. Graded Very Good.
Kenwood KR-A4070 Stereo Receiver – 60WPC, Phono, Original Remote
Sixty watts a channel into 8 ohms across the full band at 0.01% distortion, with an MM phono input at 2.5mV, a tape monitor loop, and separate bass, treble and balance. The original Kenwood remote is here, which is uncommon on a receiver of this age. Level 1 serviced; cosmetically graded Good, with honest wear for its years.
