Pioneer SX-3800 Stereo Receiver 60 WPC, Made in Japan, Cherry Cabinet
$1,495.00
📻 60 Watts Per Channel | Stereo Receiver
🎛️ Non-Switching Amplifier | 0.005% THD
💙 Iconic Blue Fluoroscan Power Meters
📡 Quartz-Locked Digital FM Tuner
🎵 Moving Magnet Phono Stage for Turntable
🔊 Dual Speaker Outputs with A/B Switching
🔌 Pre-Out / Main-In for System Expansion
🇯🇵 Made in Japan
🛠️ Level One Serviced by Radique Audio
✅ 90-Day Warranty + Perpetual Trade-Back Program
1 in stock
📻 Pioneer SX-3800 Stereo Receiver 60 WPC — Made in Japan, Cherry Cabinet
The Pioneer SX-3800 stereo receiver is one of the finest pieces to emerge from Pioneer’s acclaimed early 1980s lineup — a non-switching amplifier, quartz-locked digital tuner, and iconic blue Fluoroscan power meters, and upgraded Ottawa Valley cherry wood cabinetry that turns this already beautiful component into a genuine statement piece. Made in Japan..
🎛️ Pioneer SX-3800 Stereo Receiver — Non-Switching Amplifier Design
Manufactured from 1980–1981, the SX-3800 sat just below the flagship SX-3900 in Pioneer’s receiver hierarchy — and its amplifier section reflects that pedigree. The non-switching amplifier controls output transistor bias at high speed, eliminating crossover distortion entirely. The result is an extraordinarily clean 60 watts per channel into 8 ohms with a vanishingly low 0.005% THD — a figure that rivals many modern amplifiers. Frequency response extends from 7 Hz to 80 kHz, and a damping factor of 50 provides excellent control over demanding speaker loads.
📡 Quartz-Locked Digital Tuner & Fluoroscan Meters
The quartz-locked FM tuner pairs an analog dial with a blue fluorescent digital frequency display for precise, drift-free station lock — the quartz servo system eliminates tuning drift entirely. The distinctive blue Fluoroscan logarithmic power meters display output from 0.01 to 80 watts without range switching — a Pioneer hallmark of this era that remains as functional as it is visually captivating.
🎵 Phono Stage, Tape Loops & System Flexibility
Moving magnet phono stage — 2.5 mV input sensitivity, 82 dB S/N ratio for quiet, capable vinyl playback
Two tape monitor loops — also serve as insert points for external equalizers or signal processors
Pre-out / main-in connections — separate the preamp and power amp sections for system expansion
Dual speaker outputs with front-panel A/B switching
Subsonic filter to reduce low-frequency warp rumble from turntable playback
Headphone output
🇯🇵 Condition & Service
This unit is in very good overall cosmetic condition, with the custom Ottawa Valley cherry wood cabinetry presenting particularly well — rich colour, attractive grain, and only light signs of careful use. The faceplate, knobs, and Fluoroscan display are clean and presentable for a receiver of this vintage.
- Consistent, high-quality packaging ensures your treasured component arrives safely. Every order is packed in heavy-duty 275lb test double wall boxes (not just single wall), surrounded by industrial-grade bubble wrap, and sealed with extra-strong tape. Shipping damage is virtually unheard of. Watch our unboxing video!
📐 Specifications
| Feature | Spec |
|---|---|
| Power Output | 60 WPC into 8 ohms (20 Hz–20 kHz, 0.005% THD) |
| Frequency Response | 7 Hz – 80 kHz |
| Damping Factor | 50 |
| Phono Input Sensitivity | 2.5 mV (MM) |
| Line Input Sensitivity | 150 mV |
| S/N Ratio | 82 dB (MM phono), 110 dB (line) |
| FM Tuning Range | 87.5 – 108 MHz |
| AM Tuning Range | 525 – 1605 kHz |
| Power Meters | Blue Fluoroscan logarithmic, 0.01–80W |
| Tape Loops | 2 |
| Speaker Outputs | Dual A/B |
| Semiconductors | 17 ICs, 6 FETs, 71 transistors, 58 diodes |
| Dimensions | 19.9″ × 6.5″ × 17.1″ (506 × 164 × 434 mm) |
| Weight | 35.7 lbs (16.2 kg) |
| Origin | Made in Japan |
🌳 Caring for Your Cherrywood Cabinet
Each custom cherry cabinet is sanded to a silky 320-grit smoothness and hand-finished with boiled linseed oil and a final beeswax polish — no stains, no polyurethane, no synthetics. For tips on keeping it looking its best for decades, including safe cleaners, what to avoid, and how to manage sunlight exposure, see our Cherrywood Cabinet Care Guide. 👉
⚠️ Important Information for International Buyers
This receiver is configured for North American 110/120V power. Buyers outside North America will require a step-down transformer and appropriate plug adapter. Please consult a local electrician if you are unsure about your local voltage requirements before purchasing.
✅ Buy With Confidence — The Radique Promise
Backed by Radique’s 90-day warranty and our Perpetual Trade-Back Program. When you’re ready to move on, we’ll take it back. That’s the Radique difference.
📺 Curious about our business? Check out our YouTube channel for behind-the-scenes videos and more!
📞 Questions? Use the Ask a Question button above, or call us at 613-416-9995.
⭐ Don’t Just Take Our Word For It
Radique Audio holds over 600 customer ratings averaging 4.97 stars across six public platforms — Facebook Marketplace, Kijiji, Canuck Audio Mart, Google and others. Every rating lives somewhere we don’t control, so you can read the originals yourself, including the less flattering ones. See what our customers say. 👉
| Weight | 40 lbs |
|---|---|
| Dimensions | 21.1 × 24 × 10.5 in |
You may also like…
Ultralink High Def Power Conditioner with Display, BNIB HDC150
Eight surge-protected, filtered AC outlets with isolated banks for digital, video, audio and high-current components — four always-on, four switched.
Enough outlets for the whole stack, not just the amplifier — television, Blu-ray and streamer alongside a receiver, or turntable, CD player and cassette deck alongside a vintage amp. 3,500 joule protection, EMI/RFI filtration to 58 dB, and surge protection on the coax and network lines most conditioners leave unguarded. Patented ASP voltage monitoring and a 15 amp resettable breaker.
Brand new, unopened, in original packaging with full manufacturer warranty.
Gold Plated Pin Connectors – Flexible Pins, Radique Audio
Made for spring clips and guillotine terminals, where bare wire frays and works loose. The pin flexes rather than sitting rigid, so it does not lever on a forty-year-old terminal, and two set screws hold the wire instead of one. Takes 12 to 18 AWG — 12 is a tight fit. Colour-coded non-conductive jackets and a textured grip. Sold in 1, 2, 4 or 10 pairs.
RA-Twin II Gold Series TX Bundle
The RA-Twin II Gold Series TX Bundle pairs our exciting new Bluetooth streamer with a premium Gold Series 1/4" to 1/8" TRS cable—perfect for streaming from vintage amplifiers and home theater systems directly to your Bluetooth headphones. Save compared to purchasing separately while enjoying audiophile-quality sound and seamless wireless connectivity. 🍁
RA-Twin II Gold Series RX Bundle
RA‑Twin II Gold Series RX Bundle
Take your RA‑Twin II to the next level! This bundle pairs our fantastic, crystal‑clear RA‑Twin II Streamer with the Radique Audio Gold Series 3.5mm to Dual RCA Cable — a serious step up from the very basic starter cable included in the RA-Twin II package.
The Gold Series cable delivers superior conductivity, robust shielding, and rock‑solid connectors for richer detail, deeper bass, and a cleaner signal from your source. Translation? Your music simply sounds better.
Bluetooth Adapter for Vintage Stereo – RA-Twin II Radique Audio
FM Dipole Antenna 300 Ohm Twin-Lead Indoor with Spade Connectors
Related Products
Yamaha R-S300 Stereo Receiver — 50 WPC, MM Phono, Sub Out
A two-channel Yamaha receiver from the R-S series, 50 watts a side, with a proper moving-magnet phono stage, a subwoofer output and switching for two pairs of speakers.
✔️ Condition: Very Good — tested and confirmed working across all inputs and both speaker channels
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
JVC RX-307 Stereo Receiver — 80 WPC, Original Remote & Manual
Eighty watts a side, a proper phono input, and the two things these almost never come with any more: the original remote and the printed manual.
✔️ Condition: Very Good
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
Marantz 2245 Stereo Receiver – 45 WPC, Level 1 Serviced, Japan
A Marantz 2245 from the golden age of the receiver, serviced on our bench and wearing its original Marantz case.
✔️ Condition: Very Good — original vented woodgrain case, sound
✔️ Level 1 service on our own bench, with post-service testing
✔️ 45 WPC · MM phono stage · tape loop · pre-out / main-in · two speaker pairs
✔️ Made in Japan — confirmed on the rear rating plate
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Ottawa Valley cherry cabinet available to order
Pioneer SX-50 Silver Face Receiver – 50 WPC, Pre-Outs, 1983
Fifty watts a channel into 8 ohms at 0.007% distortion, and — unusually for a receiver this size — pre-out and main-in jacks on the back, so it can feed a subwoofer, take an equalizer in the loop, or hand off to a larger power amp. Introduced in 1983 with switchable CD and TV audio inputs, presets held by three AA cells, and the silver face of the decade that was ending. Graded Very Good.
Kenwood KR-A4070 Stereo Receiver – 60WPC, Phono, Original Remote
Sixty watts a channel into 8 ohms across the full band at 0.01% distortion, with an MM phono input at 2.5mV, a tape monitor loop, and separate bass, treble and balance. The original Kenwood remote is here, which is uncommon on a receiver of this age. Level 1 serviced; cosmetically graded Good, with honest wear for its years.
Sherwood S-7250 CP Stereo Receiver – 20WPC, Phono, Wood Cabinet
Twenty watts a channel into 8 ohms across the full 20 Hz to 20 kHz band, an MM phono input at 80 dB signal-to-noise, and a tape monitor loop. Sherwood built these in small runs in Chicago and sold them through the same shops that carried Marantz and McIntosh. Still in its original wood cabinet. Level 1 serviced here; condition Very Good.




















