Pioneer SX-980 Vintage Stereo Receiver – 80 WPC, Cherry Cabinet

Pioneer SX-980 — A Golden Age Flagship, Restored and Re-Cabineted in Ottawa

A truly stunning example of Pioneer’s late-1970s engineering at its finest — the Pioneer SX-980 stereo receiver, fully Level 2 serviced and tested, and fitted with a brand-new custom cabinet hand-built from laminated Baltic birch and finished in genuine Ottawa Valley cherry veneer. A Golden Age icon, restored and re-housed to a standard that genuinely transcends its already-considerable original quality. Made in Japan, 1978.

Where the SX-980 Sits in Pioneer’s Flagship Line

The SX-980 sits near the top of Pioneer’s celebrated SX-x80 line of 1978–1979, third in the lineup behind only the SX-1080 and SX-1280. Rated at a conservative 80 watts per channel into 8 ohms with 0.05% THD from 20 Hz to 20 kHz — and routinely measuring closer to 94 watts per channel on the bench — it delivers the kind of authoritative, effortless drive that has made Pioneer’s late-70s flagship receivers some of the most sought-after vintage audio components in the world. The amplifier section uses a constant-current-loaded two-stage differential input, direct-coupled two-stage Darlington single push-pull DC output stage, and the company’s renowned over-built linear power supply — engineering that translates directly into the warm, sweet, room-filling sound the SX-x80 series is famous for.

Design and Controls

Visually, the SX-980 is one of the most beautiful receivers Pioneer ever built. The brushed silver faceplate is covered in heavy, satisfying knobs and switches; the centre features Pioneer’s iconic blackout dial — dark when powered off, glowing with backlit cyan and white markings when switched on — with a smooth flywheel-weighted tuning knob; and the unit is anchored by a pair of mirrored, brilliantly illuminated power output meters that move with every musical transient.

The control set is genuinely deep: separate bass and treble with selectable turnover frequencies (200 Hz / 400 Hz bass, 5 kHz / 25 kHz treble), tone defeat, low and high filters (15 Hz and 8 kHz), FM muting, two complete tape monitor loops with duplication, two MM phono inputs, an aux input, mic input with muting, mode switch, loudness compensation, dual signal-strength and tuning meters, and outputs for two pairs of speakers. Pre-out / main-in jacks on the rear allow the SX-980 to be split into separate preamp and power amplifier sections, or paired with an outboard equalizer or processor.

Level 2 Service — What’s Been Done

This particular SX-980 has undergone our Level 2 service and testing — a comprehensive electronic restoration that addresses the components most prone to drift and degradation in a 47-year-old receiver, and brings the unit back to factory specification both electrically and operationally. The result is a Pioneer SX-980 that performs as it did when it left the Tokyo factory in 1978, with the kind of reliability and sonic confidence that only a properly serviced flagship can offer, and which should ensure many more years of reliable performance ahead.

The Custom Cherry Cabinet

The original Pioneer wooden case has been replaced with a brand-new custom cabinet, hand-built in our Ottawa shop from laminated 3/8-inch Baltic birch plywood, milled to the original Pioneer cabinet’s exact dimensions and profile detail, and then veneered with genuine Ottawa Valley cherry. Baltic birch is the gold standard for fine cabinetry — void-free, dimensionally stable, and dramatically stronger and more rigid than the particleboard Pioneer used in the original case — and the result is a receiver enclosure that is both visually stunning and mechanically superior to the factory original.

The Ottawa Valley cherry veneer is solid, locally sourced, and finished to show off the wood’s warm reddish-gold grain to its fullest. Cherry is unique among furniture woods in that it darkens and deepens beautifully with age and exposure to light, so this cabinet will only become more striking with the years. The match between the warm, organic cherry and the cool brushed-silver faceplate is genuinely stunning in person — our photos cannot do justice to the result, which has to be seen and handled to be fully appreciated. This is a one-of-a-kind piece of audio furniture as much as it is a high-performance receiver.

Pioneer SX-980 Specifications

• Tuning range: FM, MW (AM)
• Continuous power output: 80 W/ch into 8 ohms, 95 W/ch into 4 ohms (20 Hz – 20 kHz, 0.05% THD)
• Dynamic power output: 160 W/ch into 8 ohms, 190 W/ch into 4 ohms
• Frequency response: 5 Hz – 100 kHz
• Total harmonic distortion: 0.05%
• Damping factor: 30
• Input sensitivity: 7.5 mV (mic), 2.5 mV (MM phono), 150 mV (DIN), 150 mV (line)
• Signal-to-noise ratio: 76 dB (MM), 90 dB (line)
• Outputs: 150 mV (line), 30 mV (DIN), 1 V (pre-out)
• Speaker load impedance: 4 ohms minimum, two pairs supported
• Tone controls: Bass with 200 Hz / 400 Hz turnover, treble with 5 kHz / 25 kHz turnover, tone defeat, 15 Hz subsonic and 8 kHz high-cut filters
• Phono inputs: 2 x MM
• Tape loops: 2 with duplication
• Pre-out / main-in: Yes (split-amp capable)
• Semiconductors: 3 x FET, 8 x IC, 35 x transistors, 45 x diodes
• Power consumption: 800 W maximum
• Year of introduction: 1978
• Country of manufacture: Japan
• Dimensions (W × H × D): 20.7 × 6.9 × 17.3 inches (526 × 176 × 440 mm)
• Weight: approx. 41.5 lbs (18.8 kg)
• Cabinet: Brand-new custom build, laminated 3/8″ Baltic birch plywood milled to the original Pioneer cabinet’s dimensions and profile detail, veneered with genuine Ottawa Valley cherry

Why This SX-980 Stands Apart

A Golden Age Pioneer flagship receiver, properly serviced to factory specification and re-housed in a one-of-a-kind cabinet of laminated Baltic birch and Ottawa Valley cherry — a genuinely special piece that combines audiophile vintage performance with a level of craftsmanship and visual presence that no production receiver from any era has ever matched. Made in Japan, restored and re-cabineted in Ottawa.

⚠️ Important Information for International Buyers

This receiver is configured for North American 110/120V power. Buyers outside North America will require a step-down transformer and appropriate plug adapter.

✅ Buy With Confidence — The Radique Promise

Backed by Radique’s 90-day warranty and our Perpetual Trade-Back Program. When you’re ready to move on, we’ll take it back. That’s the Radique difference.

📦 Watch how we protect your gear — our unboxing video.

📺 Curious about our business? Check out our YouTube channel for behind-the-scenes videos and more!

📞 Questions? Use the Ask a Question button above, or call us at 613-416-9995.