Marantz 1070 Vintage Integrated Amplifier – 35 WPC, Serviced
$995.00
A slim mid-seventies Marantz integrated amplifier, through our Level 1 service, in very good condition, with a phono stage, a three-band tone section and a microphone input on the front panel.
✔️ Very good condition — free of significant marks
✔️ Through our Level 1 service on our own bench
✔️ MM phono stage, three-band tone sliders and a front-panel mic input
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
1 in stock
A slim mid-seventies Marantz integrated amplifier, through our Level 1 service, in very good condition, with a phono stage, a three-band tone section and a microphone input on the front panel.
What it is
The 1070 belongs to the slim-chassis family Marantz built in the mid-seventies alongside the 1060 amplifier and the 112 tuner, all sized to sit in the same wood case. It is rated at 35 watts per channel into 8 ohms across the full 20 Hz to 20 kHz band at 0.3% distortion, and it carries a proper MM phono stage for your turntable. Designed in the USA and built in Japan, 1975 to 1978.
The front panel gives you more control than most amplifiers of its size. The tone section has three sliders, bass, mid and treble, where most of its rivals stopped at two, so you can shape the vocal range without touching the bottom or top end. There are high and low filters for noisy records and rumble, a loudness switch, a balance slider, and a mode selector that runs left, right, stereo, reverse and mono. The input selector takes a microphone as well as phono, tuner, aux and two tape decks, with a front-panel mic jack beside the headphone socket.
Around the back, the preamplifier and power amplifier sections are linked by pre-out and main-in jacks, so they can be separated to add an equalizer or to use either half on its own. Both tape loops have RCA jacks and a DIN socket. There are terminals for a main and a remote or ambience pair of speakers, a chassis ground post, and two AC outlets, one switched and one unswitched, for a turntable or tuner.
It is shown bare, in its factory black metal case. If you would like it in wood, a walnut-grain cabinet sized for the 1070 is listed separately.
The service it has had
Level 1 service, carried out on our bench:
Condition
Very good, and free of significant marks. The brushed silver faceplate, the knobs and sliders, the panel legends and the black case all present well, as the photographs show.
A clean, fully serviced mid-seventies Marantz in the slim chassis, with the controls of a much bigger amplifier.
Available for pickup in Kanata, or shipped across Canada and internationally — we have sent equipment to fifteen countries in the past year, each piece packed in-house in 275 lb test double-wall boxes. Live shipping rates for your address are calculated at checkout. Backed by Radique Audio’s Bumper-to-Bumper Warranty and our Perpetual Trade-Back Program. Available for audition by appointment in Kanata.
Marantz 1070 Specifications
- Every input, output and control tested
- All pots and switches deep-cleaned and deoxidized
- Any blown indicator lamps replaced
- Power supply wiring checked and cleaned
- Burn-in and sign-off testing
- A second bench test by a different tech before listing
- Type: stereo integrated amplifier
- Service: Radique Level 1
- Power output: 35 watts per channel into 8 ohms, 20 Hz – 20 kHz, 0.3% THD
- Damping factor: 20
- Input sensitivity: 1.8 mV (MM phono), 180 mV (line)
- Tone controls: bass, mid and treble sliders, loudness
- Filters: high and low
- Inputs: phono (MM), tuner, aux, microphone, two tape loops with RCA and DIN sockets
- Outputs: main and remote or ambience speaker pairs, headphones, pre-out
- Pre-out and main-in: yes, the sections can be separated
- AC outlets: 1 switched, 1 unswitched
- Power: 120 V
- Designed in the USA, made in Japan, 1975–1978
- Dimensions: (Width x Height x Depth) 14.2 x 4.7 x 11 inches (360 x 120 x 280 mm)
- Weight: 18.5 lbs (8.4 kg)
🎚️ Gold Series RCA Interconnects
Our own Gold Series RCA Stereo Interconnect is a shielded, gold-plated stereo pair, in stock and ready to go. It is the cable that connects this to the rest of your system, and it is a straightforward upgrade on the free leads that come in the box with most equipment. 👉
🔌 Speaker Cable, Built on Our Own Bench
We hand-build speaker cable here in any length you need — pick the gauge and the terminations on our Custom Speaker Cable Builder. We also make our own gold-plated banana plugs, spades and pin connectors if you would rather terminate cable you already have. 👉
📶 Add Bluetooth — The RA-Twin II, Built For Exactly This
The 1070 was built decades before Bluetooth reached home stereo, and it does not need replacing to get it. Our own RA-Twin II adapter plugs into the aux or a tape input on the back and streams from a phone, tablet or laptop — nothing modified inside, and it comes with a starter cable so it works out of the box. If you want it done properly, the Gold Series RX Bundle pairs the adapter with our shielded Gold Series 3.5 mm to Dual RCA cable for less than buying the two separately. 👉
⚠️ Important Information for International Buyers
This unit is configured for North American 110/120V power. Buyers outside North America will require a step-down transformer and appropriate plug adapter.
✅ Buy With Confidence — The Radique Promise
Backed by Radique Audio’s Bumper-to-Bumper Warranty and our Perpetual Trade-Back Program. When you’re ready to move on, we’ll take it back. That’s the Radique difference.
📦 Watch how we protect your gear — our unboxing video.
📺 Curious about our business? Check out our YouTube channel for behind-the-scenes videos and more!
📞 Questions? Use the Ask a Question button above, or call us at 613-416-9995.
| Weight | 20.5 lbs |
|---|---|
| Dimensions | 15 × 18.2 × 8.7 in |
You may also like…
Walnut-Grain Cabinet for Marantz 1060, 1070, 112 (WC-10 Size)
A WC-10-size cabinet for Marantz’s slim-chassis components, clad in walnut-grain vinyl.
✔️ Very Good condition
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
RA-Twin II Gold Series RX Bundle
The RA-Twin II plus our shielded Gold Series 3.5 mm to dual RCA cable: stream from your phone to any vintage receiver, amplifier or powered speakers, for less than buying the two separately.
- RA-Twin II Bluetooth 5.4 adapter (RX, TX and Mobile modes)
- Gold Series 3.5 mm to dual RCA cable, shielded and gold-plated
- No noise after streaming stops
- Clear online manual in English & French
- 1-year warranty, Ottawa-based support
Gold Series RCA Stereo Interconnect | Radique Audio
Radique Audio Gold Series RCA Stereo Interconnect — dual RCA to dual RCA with vintage-safe, gold-plated connectors and 6-layer shielded construction. Featuring 262 strands of tinned copper, dual-layer copper and foil shielding, and slim narrow-profile connector barrels designed to fit tightly spaced vintage RCA jacks. Available in 0.2 m, 0.75 m, and 1.5 m lengths. Audiophile quality without the audiophile pricing.
Custom Speaker Cable Builder
🎯 Your specs, your cable — choose cable type, length & connectors
💰 Live pricing — price updates instantly as you configure
↔️ Bi-wire capable — available on Kimber 4PR, Kimber 4TC and House Quad
🔥 Heat-shrink reinforced — colour-coordinated at every termination & joint
🍁 Hand-assembled in Ottawa — backed by our Bumper-to-Bumper Warranty
Related Products
Harman Kardon PM640VXi Vintage Integrated Amp – 45 WPC, Japan
A 45-watt amplifier built by a company that spent the 1980s arguing the watts were the wrong thing to look at.
✔️ Condition: Very Good
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
Marantz 1200 Vintage Integrated Amplifier – 100 WPC, Made in USA
Marantz's flagship integrated of the early seventies, built in Sun Valley, California, through our Level 2 service and playing as it should.
✔️ Very Good condition — faceplate and knobs present well, light marks of age; offered in the stock black metal case
✔️ Through our Level 2 service — a substantial round of component replacement on the bench, then bias and offset set and the amp run in
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
Luxman LV-90 Vintage Integrated Amplifier – 35 WPC, Phono, Japan
Denon PMA-600NE Integrated Amplifier – 45 WPC, Phono, Bluetooth
Braun Atelier A1 Vintage Integrated Amp – 55 WPC, Pre-Out, Japan
The component that makes the rest of an Atelier system work, and the one people hunting these usually look for first. 55 watts per channel into 8 ohms and 80 into 4, with a preamplifier section that separates from the power stage — engineering that is not an afterthought to the industrial design. 445 mm wide and 70 mm tall, the exact footprint of the T1 tuner and C1 deck, so the stack reads as one machined object. Made in Japan for Braun. Good condition.
Luxman F-105 Vintage Preamplifier + Power Amp – Dolby, Japan
Arcam Alpha 5 Integrated Amplifier – 40 WPC, Made in England
A British integrated amplifier from Arcam's Cambridge factory, 40 watts a side, built on the principle that anything which does not improve the sound does not go in the box.
✔️ Condition: Very Good — tested and working properly
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping















