Sherwood S-8250 CP AM/FM Stereo Receiver 25 WPC
$295.00
Twenty-five watts a channel into 8 ohms from Sherwood’s Certified Performance series — the range where Sherwood printed the measured figures for the individual unit rather than for the model. MM phono, noise filter, mute/mono, loudness and A/B speakers, behind a brushed aluminium face with walnut-grain side panels. Level 2 serviced here: bias and DC offset set, every control deoxidised.
1 in stock
Sherwood S-8250 CP AM/FM Stereo Receiver 25 WPC
The Sherwood S-8250 CP is a handsome vintage solid-state stereo receiver from Sherwood’s early-1980s Certified Performance series — a range in which Sherwood guaranteed and printed the actual measured performance specifications of every unit, giving buyers a level of assurance few competitors could match.
Twenty-five watts per channel into 8 ohms is a modest but honest figure that goes a long way in practice, especially when driving efficient bookshelf or standmount speakers in a small to medium-sized room. The S-8250 CP has a warm, smooth analog presentation typical of the era — neither bright nor aggressive — and is well suited to vinyl listening, FM radio, and tape playback alike. The phono stage is fully capable and ready for use with any standard moving-magnet cartridge.
The front panel is classic early-1980s silver styling at its best: a wide brushed-aluminum faceplate flanked by walnut-grain side panels, a large backlit analog tuning dial with green indicator lights and a weighted flywheel tuning knob, and a full suite of discrete controls including separate Bass, Treble, Balance, and Volume knobs. A front-panel noise filter and Mute/Mono mode switch are welcome practical additions. The loudness contour switch and A/B speaker selector round out a well-considered feature set.
This unit has undergone our Level Two service and testing — including component checks and replacements as needed, bias and DC offset adjustment, and thorough deoxidation of all controls — and should ensure many more years of reliable performance ahead.
Type: AM/FM stereo receiver, solid-state
Power output: 25 watts per channel into 8Ω (stereo)
Tuner: AM and FM stereo
Inputs: Phono (MM), Aux, Tape Monitor loop (source/monitor switching)
Speaker outputs: A and B pairs (4–16Ω compatibility); spring-clip terminals
Front controls: Bass, Treble, Balance, Volume, Loudness, Noise Filter, Mute/Mono, Speaker A/B selector, Input selector
Convenience outlets: Switched (100W max) and unswitched (150W max) AC outlets on rear panel
Finish: Brushed aluminum faceplate with walnut-grain side panels
Dimensions: (Width x Height x Depth) 18.5 x 5.25 x 12.5 inches (470 x 133 x 318 mm)
Weight: 18 lbs (8.2 kg)
A properly serviced example of Sherwood’s classic CP-series styling — visually striking, sonically smooth, and ready to anchor a vintage-inspired stereo system.
Backed by Radique Audio’s 90-day warranty and our perpetual trade-back policy, you can purchase with confidence.
| Weight | 20 lbs |
|---|---|
| Dimensions | 16.5 × 22.5 × 9.25 in |
Related Products
JVC JR-S201 Receiver – 35 WPC, Japan, SEA EQ, Excellent
Thirty-five watts a channel at 0.01% distortion with a damping factor of 70 — numbers most larger receivers of 1978 could not reach. A five-band S.E.A. graphic equalizer sits on the front panel at 40, 250, 1k, 5k and 15kHz, alongside MM phono, two tape loops and push-button speaker terminals. Made in Japan, arrived professionally serviced; cosmetically graded Excellent.
Pioneer SX-50 Silver Face Receiver – 50 WPC, Pre-Outs, 1983
Fifty watts a channel into 8 ohms at 0.007% distortion, and — unusually for a receiver this size — pre-out and main-in jacks on the back, so it can feed a subwoofer, take an equalizer in the loop, or hand off to a larger power amp. Introduced in 1983 with switchable CD and TV audio inputs, presets held by three AA cells, and the silver face of the decade that was ending. Graded Very Good.
Kenwood KR-A4070 Stereo Receiver – 60WPC, Phono, Original Remote
Sixty watts a channel into 8 ohms across the full band at 0.01% distortion, with an MM phono input at 2.5mV, a tape monitor loop, and separate bass, treble and balance. The original Kenwood remote is here, which is uncommon on a receiver of this age. Level 1 serviced; cosmetically graded Good, with honest wear for its years.
Sherwood S-7250 CP Stereo Receiver – 20WPC, Phono, Wood Cabinet
Twenty watts a channel into 8 ohms across the full 20 Hz to 20 kHz band, an MM phono input at 80 dB signal-to-noise, and a tape monitor loop. Sherwood built these in small runs in Chicago and sold them through the same shops that carried Marantz and McIntosh. Still in its original wood cabinet. Level 1 serviced here; condition Very Good.
Luxman R-117 Flagship Stereo Receiver — 160 WPC, MM & MC Phono
Aurex (Toshiba) SA-5000 Stereo Receiver — 50 WPC, Made in Japan
Yamaha R-S300 Stereo Receiver — 50 WPC, MM Phono, Sub Out
A two-channel Yamaha receiver from the R-S series, 50 watts a side, with a proper moving-magnet phono stage, a subwoofer output and switching for two pairs of speakers.
✔️ Condition: Very Good — tested and confirmed working across all inputs and both speaker channels
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
JVC RX-307 Stereo Receiver — 80 WPC, Original Remote & Manual
Eighty watts a side, a proper phono input, and the two things these almost never come with any more: the original remote and the printed manual.
✔️ Condition: Very Good
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping













