Dynaco A-35 Floor Standers — Ottawa Valley Cherry, Denmark
$595.00
A pair of the famous Dynaco A-35 floor-standing loudspeakers, rebuilt in our shop with brand-new cabinets in genuine Ottawa Valley cherrywood veneer, expertly applied by hand, serviced, and fitted with upgraded five-way binding posts.
✔️ Condition: not graded with a word in the copy — cabinets are new work; drivers “through our service bench and perform as they should”; grilles NOT included
✔️ claimed, level unspecified — “been through our service bench”
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Expertly packed for safe shipping
1 in stock
A pair of the famous Dynaco A-35 floor-standing loudspeakers, rebuilt in our shop with brand-new cabinets in genuine Ottawa Valley cherrywood veneer, expertly applied by hand, serviced, and fitted with upgraded five-way binding posts.
Most fifty-year-old loudspeakers wear their age on the outside. Vinyl woodgrain wrap lifts at the corners, veneer edges scuff white, and cabinets that once looked like furniture end up looking like something out of a basement. These do not have that problem, because the cabinets are new work.
Why cherrywood
Cherry is among the most prized hardwoods in North American furniture making, and it is the only wood we use for this. Its grain is warm and close, and unlike almost anything else it improves with time — Ottawa Valley cherry finished naturally, without harsh chemicals, gradually darkens and deepens over the years into a rich, lustrous patina. A cherry cabinet looks better a decade from now than the day it leaves us. Because the grain is natural it varies from panel to panel, which is what makes each pair its own.
The finishing
The veneer is book-matched, so the grain runs continuously across the cabinet rather than stopping dead at every corner. It is sanded to a silky 320-grit smoothness before a traditional boiled linseed oil finish is hand-applied and left to cure fully, drawing the depth of the grain out from within the wood rather than laying colour on top of it. A final coat of beeswax polish gives a warm, subtle lustre and lasting protection. No stains, no polyurethane, no synthetics — made with care rather than chemicals. This is furniture-grade work, and it is the same process we use on our own cabinets.
What is inside them
Dynaco was founded in Philadelphia in 1955 and spent two decades doing what the industry has never found easy: building genuinely high-quality components that ordinary people could afford. For their loudspeakers they went to Denmark, and the Danish-built A-series is the reason the name still carries weight with people who know.
The A-35 is the one enthusiasts of the marque tend to argue for. It followed the well-loved A-25 and kept both of its drivers, but housed them in a larger and considerably more complex enclosure with a redesigned crossover. The result has deeper, better-defined bass and more dynamic capability than its predecessor — controlled rather than boomy, and noticeably more articulate. A good many people who know the range well consider it the best speaker Dynaco ever built.
It is a two-way design. A soft hemispheric tweeter handles the top with unusually wide dispersion, crossing over at 1200 hertz to an extended-excursion ten-inch woofer. That woofer deserves a moment: it uses a rubber surround rather than foam. Foam surrounds crumble with age, and a great many vintage speakers of this era now need reconing because of it. Rubber does not, which is a large part of why these still perform as they should and why they will keep doing so.
The enclosure is cleverer than it looks. Two sealed chambers sit inside, separated by a damped vent, so that as frequencies drop the effective volume of the cabinet grows. It is a neat piece of engineering that gives the low end genuine weight without the one-note thump that afflicts many sealed designs. On the rear panel a selector lets you lift or soften the midrange and treble to suit your room, which earns its keep if you have a lot of glass or a lot of carpet.
They are happy on anything from 20 to 60 watts per channel, which puts a great many vintage receivers and modern integrated amplifiers squarely in range.
The sound is warm and unhurried, with a natural tonality and real depth — rich through the midrange, sweet at the top. This is a speaker that rewards long listening rather than one that shows off, and the people who love these love them for exactly that.
The other upgrade
We have replaced the original spring-clip connections with five-way binding posts, so you can use bare wire, spades, or banana plugs, and you are no longer working around a connector designed in 1972.
Condition
The cabinets are new work, finished throughout, and both speakers have been through our service bench and perform as they should.
Two things to be plain about before you buy. The grilles are not with them. These are sold as bare cabinets, and original A-35 grille frames are not easy to find second-hand, so if you were counting on running them covered you should know that now rather than later. For what it is worth, we would run a pair finished like this uncovered anyway — but that is a preference, not an answer to a missing part.
The second is that the cabinets are our own work rather than a restoration to factory specification, so a collector after original Danish walnut should know that going in. What this is instead is a pair of A-35s in cabinets built to outlast the drivers.
A few relevant specifications:
One of the great loudspeakers of the era, in cabinets that will look better in ten years than they do today.
Available for pickup in Kanata, or shipped across Canada and internationally — we have sent equipment to fifteen countries in the past year, each piece packed in-house in 275 lb test double-wall boxes. Live shipping rates for your address are calculated at checkout. Backed by Radique Audio’s Bumper-to-Bumper Warranty and our Perpetual Trade-Back Program. Available for audition by appointment in Kanata.
Dynaco A-35 Specifications
- Two-way sealed design, sold as a pair
- Cabinets: genuine Ottawa Valley cherrywood veneer, book-matched
- Veneer preparation: sanded to 320-grit
- Finish: traditional boiled linseed oil, hand-applied and fully cured, with a final beeswax polish. No stains, no polyurethane, no synthetics
- 10″ extended-excursion woofer with rubber surround
- Soft hemispheric wide-dispersion tweeter
- Crossover at 1200 Hz
- Twin sealed chambers with a damped internal vent
- Rear-panel midrange and treble selector
- Recommended amplifier power: 20 to 60 watts RMS per channel
- Upgraded five-way binding posts
- Grilles: not included
- Made in Denmark
- Grain pattern varies naturally; deepens and darkens beautifully with age
- Dimensions: (Width x Height x Depth) 12.5 x 21.5 x 10 inches
- Weight: 22.5 lbs each
🔌 Speaker Cable, Built on Our Own Bench
We hand-build speaker cable here in any length you need — pick the gauge and the terminations on our Custom Speaker Cable Builder. We also make our own gold-plated banana plugs, spades and pin connectors if you would rather terminate cable you already have. 👉
🌳 Caring for Your Cherrywood Cabinet
Each custom cherry cabinet is sanded to a silky 320-grit smoothness and hand-finished with boiled linseed oil and a final beeswax polish — no stains, no polyurethane, no synthetics. For tips on keeping it looking its best for decades — safe cleaners, what to avoid, sunlight management — see our Cherrywood Cabinet Care Guide. 👉
✅ Buy With Confidence — The Radique Promise
Backed by Radique Audio’s Bumper-to-Bumper Warranty and our Perpetual Trade-Back Program. When you’re ready to move on, we’ll take it back. That’s the Radique difference.
📦 Watch how we protect your gear — our unboxing video.
📺 Curious about our business? Check out our YouTube channel for behind-the-scenes videos and more!
📞 Questions? Use the Ask a Question button above, or call us at 613-416-9995.
| Weight | 60 lbs |
|---|---|
| Dimensions | 14.5 × 16 × 27 in |
| impedance | imp-8 |
| power-handling | ph-51-100 |
| woofer-size | woofer-10 |
You may also like…
Gold Plated Banana Plugs by Radique Audio – Dual Set Screws
Dual set screws rather than a single screw or a compression sleeve, so the wire is held at two points and will not work loose behind the rack. Six-leaf gold-plated springs for a tighter grip in the binding post, full-length non-conductive jackets colour-coded for polarity, and gentle knurling that will not fray heavy cable. 19.4 g a pair, 25% heavier than the brand we used to carry. Fits 12 to 18 AWG.
Custom Speaker Cable Builder
🎯 Your specs, your cable — choose cable type, length & connectors
💰 Live pricing — price updates instantly as you configure
↔️ Bi-wire capable — available on Kimber 4PR, Kimber 4TC and House Quad
🔥 Heat-shrink reinforced — colour-coordinated at every termination & joint
🍁 Hand-assembled in Ottawa — backed by our Bumper-to-Bumper Warranty
Related Products
Tannoy Profile 633 (D30) Towers — Black Ash, UK-Built, Bi-Wire
Definitive Technology BP-10 4-Driver Bipolar Towers — USA-Built
Each tower is two complete two-way systems, one facing forward and one facing directly backward, both radiating in phase. That is the whole point: where a dipole panel's front and rear bass partially cancel and the speaker has to come several feet into the room, these reinforce each other and the tower is happiest eight to twelve inches off the wall. Four drivers a side, bass to 20 Hz, built in Baltimore. Graded Good, and the grade is the high-gloss end caps — three decades of black lacquer carries scuffs and a few small chips.
Tannoy Mercury F3 Slim Floorstanding Speakers — Apple Finish
A two-way floorstander built on a deliberately simple recipe: one 6.5 inch bass and midrange driver covering everything below a 1 inch textile dome, crossed at 2.7 kHz by a fourth-order Linkwitz-Riley — no midrange handover in the region the ear is most sensitive to, and drivers that sum flat and stay in phase through the crossing. 89 dB into a nominal 8 ohms, happy on anything from 10 to 100 watts, and eight inches wide. The light Apple finish hardly ever comes up. Very Good condition.
Totem Acoustic Sttaf Floorstanders — Maple, Made in Canada
Totem's slim, hand-built Montreal floorstander in the maple veneer the factory charged extra for — a single 5.5-inch driver and a textile dome in a narrow mono-shell cabinet that images far wider than its size and reaches 39 Hz. Happiest at civilised levels in a small to medium room. Fitted here with Radique Audio bi-wire bridges. Pair, ships from Kanata, ON.
Totem Claw Speaker Isolation Feet — Set of 6, Machined Aluminum
Totem's own decoupling feet — the same machined aluminium Claws the factory fits to the Forest and the Wind — as a complete set of six, enough for one pair of speakers at three per cabinet. They fix with the included self-tapping screws, so no threaded insert is needed, and work on hardwood, tile or concrete where spikes do not. Ball bearings included.
Monitor Audio Bronze 3 Towers — Shot-Loaded, Made in England
Paradigm 11se Mk II Towers, Pair — Dual 8″, Made in Canada
Built in Canada by Paradigm, and the largest speaker in the SE range — the one the rest of the series was working up to.
✔️ Condition: Good — cabinets touched up; repaired and working correctly
✔️ repaired, unattributed — Mark said "repaired now", not who; NO Level stated; do not attribute it to our bench without Mark naming it
✔️ Sold as-is — for parts or repair, no warranty
✔️ Curbside delivery, local collection or freight within Canada
Klipsch RF-62 Reference IV Floorstanding Speakers, Pair — 97dB
The RF-62 is the tower that made Klipsch's Reference line the default answer for anyone who wanted a big, unforced sound without buying a big, expensive amplifier to get it.
✔️ Condition: Good — cabinets carry touched-up wear; drivers Very Good throughout
✔️ Covered by Radique Warranty
✔️ Includes Perpetual Trade-Back Program eligibility
✔️ Curbside delivery, local collection or freight within Canada












